Burks B-Lift450L sewage lifting pump station

Brief introduction

B-Lift450L is a large automatic sewage lifting pump. Applicable to no

The sewage can be directly discharged to the main sewer by natural downward gravity

The place.

application

B-Lift450L is mainly used for:

Discharge of large-scale commercial complex, public enterprises and public institutions, and large-scale public enterprises

The domestic sewage produced by common places and multi family is improved, which is suitable for sustainable development

Large discharge drainage site.

(if the liquid being pumped contains other hard objects, it may cause

This kind of failure is not covered by the warranty).

Pumping liquid

It is formed by sewage and rainwater produced by large-scale life

It's sewage.

● allowable liquid temperature: 45 ℃ C maximum

● domestic wastewater and surface sewage.

Allowable liquid pH: 4-10.

Strong chemical solvents are not allowed.

When installing the flange, the eccentricity should be adjusted by rotation

After the opening position, tighten the screw and remove the eccentric opening

It can be connected with PVC pipe of Φ 160 (installation flange

All openings are 150 mm)

Installation procedure

Tools to be used: electric hand drill, 100 mm, 150 mm

Hole opener (water inlet opening), 50mm opening device (water inlet opening, through

Air port opening), slotted screwdriver.

1: the external double pump series has only one outlet pipe, and the outlet pipe diameter is

90 mm od PVC water supply pipe or DN80 galvanized steel pipe, and

The field outlet pipe butt joint uses flange connection or soft connection, which can be configured

The big and small heads are connected with the pipe diameter on site. (special glue

Connect the outlet pipe, pay attention to use PVC water supply glue, and the equipment has its own check

Valve, it is necessary to install the stop valve in the water outlet pipeline when installing)

2: the ventilation port of the equipment can be connected to the PVC drainage pipe with the outer diameter of 50mm

If it is not in line with the field pipe diameter, the reducer can be used to reduce the diameter of the pipe

It is connected to the ventilation port, and the ventilation pipe and equipment are made of stainless steel hoop

The connection is provided by itself. (connect the outlet pipe with PVC

The installation requirements of water glue and vent pipe are higher than that of roof or higher than that of roof

Outdoor green belt)

● 3-4: there are 7 Φ 160 and Φ 110 water inlet reserved in the external double pump series

According to the needs of the site water intake, the,

The corresponding water inlet opening connecting pipeline can be selected by oneself.

Φ 110 rubber connection Water inlet and both sides of the boxIntake)

Φ 50 rubber flexible joint (connection Air vents and both sides of the box Intake)